Mostiglass® door

Mostiglass® door

Designed to be adapted to doors, the Mostiglass® door is made up of two elements: the opening (or leaf) of the Mostiglass® door, integrating the rigid Mostiglass® glazing, and the frame.
A magnetic closure system allows these two elements to close the assembly.

It is installed in the door panel or on the wall, like a storm door or "American door".
Mostiglass® door Mostiglass® door

The Mostiglass® door
and its advantages

Storm door system

This product is presented as an American-style storm door, offering a robust security solution while integrating the distinctive characteristics of Mostiglass.

Adapted to frequent use

The Mostiglass® door is a “high traffic door“: it is specially designed to withstand frequent opening and closing cycles.


It is possible to install an optional lock with key on the door to increase the security of your opening.

Basic colors available

3 basic colors are available for the frame: white (RAL9010), anthracite grey (RAL7016) and light grey (RAL9006).

They cover most aesthetic needs.

More than 150 colors (RAL) optional

Our frames offer a wide range of optional colors, with over 150 shades available according to the RAL color chart.

svg svg

Additional information

The Mostiglass® door offers many advantages
but additional information are issued regarding the use of this product.

Using a drill

Installation of this product presents no particular difficulties. The use of a drill is recommended for the fixing points on the wall.

Swing shutters

The presence of swing shutters may present an obstacle to the installation of the Mostiglass® door.

Do you have a project and would like an estimate for this product?

Make an estimate for the product single leaf door

Installation of the Mostiglass® door

Schéma porte

Door positioning

The door is pre-assembled.
Position the door in the intended location. Two systems are possible:

  • in the masonry panel, (recommended system)
  • surface mounted, against the exterior wall (offset profiles are intended to recreate the conditions of a table)
If necessary, position shims under the lower part of the Mostiglass® door so that the whole “frame – opening” is horizontal.
The upper crosspiece of the Mostiglass® door must be as close as possible to the panel.


Fixing the door

Mark the position of the frame with a pencil.
The fixing system is pre-drilled, no additional drilling is required in the case.
Screw into the reveal, using a drill and hardware suitable for the nature of the wall is necessary.
Tip: check after each screwing that the sash closes correctly, the corresponding magnets.


Hinge adjustment

When the door is correctly fixed, tension the spring hinges with a hex key.

Frequently asked questions
about the Mostiglass® door

Make an estimate